What's special about this thermo-shield tape?
- Fiberglass-aluminum composite material reflects up to 90% of radiant heat
- Prevents rubber or plastic hoses and wiring components from melting, drying out, or cracking in the presence of extreme heat (up to 2,000° F, or 1,093° C)
- Adhesive backing provides a secure and durable bond
- Perfect for splicing the ends of heat-shield tubing, or for wrapping pre-installed components that can’t be easily disconnected
- Gives a clean and professional appearance
- Click for More Features
Thermo-Shield is an adhesive backed composite tape that can be used to wrap hoses or wires. Radiant and conductive heat can melt, or dry out, the rubber and plastic components in hoses and wiring, causing them to leak or short out. This wrap can protect these hoses and wires from that heat and extend their lifetime.
|TS-14002||1-1/2" x 15' Roll Thermo-Shield Tape||0.72 lb|
While giving a clean and professional appearance, parts are protected from over 90% of radiant heat up to 2,000° F. Thermo-Shield can be used in applications where it is not practical or convenient to disconnect one end of the hose or wire.
- Reflects up to 90% of radiant heat
- Withstands temperatures up to 2,000° F (1,093° C)
- Adhesive backing for secure application
- Great for splicing heat shield tubing ends
|Product:||Haveglas Fiberglass Textiles
Aluminum Foil Lamination/PSA Lamination
I. Composition & Information on Ingredients
|Ingredient(s)||CAS Number||Approx. Percent|
II. Hazard Identification
|Off white or tan colored flexible woven fabric with no odor|
|Effects of Overexposure|
Slight irritation may be caused in contact with eyes
Temporary irritation of skin may be produced
Inhalation of airborne fibers may cause irritation to the mouth, nose, and throat.
May cause temporary irritation of the digestive tract, but not an expected route of entry in industrial uses.
There are no known chronic health effects associated with the use of this product under normal working conditions.
|Primary routes of entry:
Skin contact, inhalation, ingestion, & eye contact
None of the components present in this material at concentrations equal to or greater than 0.1% are listed by IARC, NTP, OSHA, or ACGIH as a carcinogen.
III. First Aid Information
Flush eyes immediately with large amounts of water for at least 15 minutes holding eyelids open while flushing. Seek medical attention promptly.
Wash contaminated skin thoroughly with mild soap and cool water. Seek medical attention if irritation persists.
Remove person from source of exposure and then seek medical attention immediately.
Seek medical attention immediately.
IV. Fire Fighting Measures
|Flash Point: N/A
Lower Explosive Limit (%): N/A
Upper Explosive Limit (%): N/A
|Auto-Ignition Temperature: Non-Determined|
Carbon dioxide, water, foam, or dry chemical as suitable for type of surrounding fire
|Unusual Fire & Explosion Hazards: N/A|
|Fire Fighting Instructions:
Wear full fire fighting protective equipment including self-contained breathing apparatus.
V. Accidental Release Measures
Steps to be taken in case material is released or spilled:
Dust or loose fibers can be vacuumed or swept with the aid of a dust suppressant. Dispose according to federal, state, and local environmental regulations.
VI. Handling and Storage
Store material in a clean dry place, and keep container closed.
Particular care should be taken when working with "used" material to minimize dust. If exposure limits are exceeded or if irritation is experienced, NIOSH approved respiratory protection should be worn.
VII. Exposure Controls and Personal Protection
General ventilation and/or local exhaust ventilation should be utilized to maintain exposures below the Threshold Limit Value (TLV).
Use and approved disposable dust respirator designed for nuisance type dusts.
Safety glasses with side shields or chemical splash goggles must be worn to prevent eye contact. A good safety practice is to have an eyewash station readily available near the work area.
Wear rubber gloves when handling this product. Personnel that are more susceptible to irritation from fibers or dusts should wear full-body coveralls.
Use good personal hygiene practices. The use of protective creams before handling the material may prove beneficial.
PEL (OSHA) 5 mg/m³ (respirable), 15 mg/m³ (total)
TLV (ACGIH) 5 mg/m³ (able to inhale)
NIOSH 5 mg/m³ (total), 3 fibers/cm³ (fibers ≤ 3.5 µm in diameter and ≥ 10 µm in length)
VIII. Physical and Chemical Properties
|Solubility in Water||Negligible|
|Color:||Off-white or tan colored|
|Physical State||Woven fabric|
IX. Stability and Reactivity
|Chemical Stability||Product is stable at normal temperature and storage conditions|
|Incompatibilities||Phosphoric acid, hydrofluoric acid, and strong hydroxides|
|Hazardous Polymerization||Hazardous polymerization will not occur under normal conditions|
|Hazardous Decomposition Products||N/A|
X. Toxicological Information
Industry studies have shown textile grade fiberglass to be a non-carcinogen.
XI. Ecological Information
No information is available; however, toxicity is expected to be low based on the insolubility in water of the product.
XII. Disposal Considerations
Dispose of waste material in accordance with applicable federal, state, and local environmental regulations.
XIII. Transportation Information
DOT Proper Shipping Name: Haveglas Fiberglass
DOT Hazardous Class: None
DOT UN/NA Number: None
Emergency Response Guide Number: None
XIV. Regularity Information
|U.S. Federal Regulations as follows:|
|SARA Section 313: This product contains the following substances subject to the reporting requirements of Section 313 of Title III of the Superfund Amendment and Reauthorization Act of 1986 and 40 CFR Part 372|
|TSCA: The chemical substances in this product are exempt from the TSCA Section 8 Inventory per Section 8(a). 710.2(f), and 704.5(a).|
|Export Notification: None|
|International Regulations as follows:|
|Canadian WHMIS: This MSDS has been prepared in compliance with Controlled Product Regulations except for the use of the 16 headings.|
|Canadian WHMIS Class: Not Regulated|
|DSL: The chemical substances in this product are listed on the Domestic Substances List (DSL).|
The above information is believed to be accurate based on the most current data available. Ametek makes no warranty, either expressed or implied, with respect to such information, and assumes no liability resulting from its use. Users are advised to conduct their own tests to determine the safety and suitability of each product or product combination for their own purposes. Ametek shall not be liable for any claims, losses, or damages of any third party or for lost profits or incidental or consequential damages, howsoever arising even if Ametek has been advised of the possibility of such damages.
RELATED ARTICLES -
Do you have any question about this product?
Let our experts and customers resolve all your doubts
Did you know that we can give you a quote for most of our products, including shipping?
You can also call us toll free 866.222.0030