Rack-a-Tiers Pipe Spring Bender

NOTE: Pipe should be 60° F or warmer.

The Pipe Spring Bender is designed to be used over and over for years of service. Flexible and strong, the springs are inserted into the pipe to give support to the pipe walls during manual bending. The diameters of the springs are only slightly less than the internal diameter of the pipe to be bent.

• Faster and easier than having to cut and/or glue the fittings from the factory
• No need for elbows or angled fittings, just bend and go
• Maintains the inner diameter of the pipe so there are no issues when trying to run cable through
• Save time and money with this cost efficient bender system
• Lightweight, anti-corrosive and so easy to use – this is one tool you need to keep with you always
• Available in 1/2”, 3/4” and 1" diameter sizes
• 1-year manufacturer limited warranty

Perfect for electricians, plumbers, data & telecom installers and anyone who works with schedule 40 PVC pipe/conduit.

How to Use -

To keep your spring from getting lost inside of the pipe, tie a piece of cord to the end of the spring long enough to hang out of the end. Place the spring inside the pipe at the location of the bend. If necessary, lubricate the spring with a little petroleum jelly. If the spring still will not slide in, perhaps consider a different size spring.

Once the spring is in place, begin to bend the pipe to the appropriate angle by gently pulling both ends around your knee. Be sure to avoid bending it too far, although going a bit past the desired angle is recommended. Keep in mind that even with a spring inside, excessive bending will cause the pipe wall to collapse. Once you are satisfied, pull the spring out using the cord.

NOTE: Pipe should be 60° F or warmer.

RELATED ARTICLES

• The 10 Commandments of Cable Management
• 10 Easy Ways to Protect Against Electrical Hazards
• Hole Saw FAQ's