Leviton Vizia+™ Decora® Digital 600 Watt Incandescent Dimmer

These commercial-grade controls can also be used for residential dimming applications. Each dimmer control contains a white paddle with kits that contain almond and ivory or light almond faceplates if you wish to change the color.

• Made with digital circuitry that is easy to operate
• The return to neutral push pad makes all your Vizia controls line up evenly for an attractive appearance on the wall
• Advanced programming allows you to set brightness modes, fade on or off ,and apply an energy saving mode to control maximum brightness
• Provides 7 full-range light settings to lower or raise light intensity and brightness
• Memory on each dimmer saves the last setting used as the brightness level, even during regular use or power interruptions. It can be reset at any time, even when the switch is turned off
• The green LED acts as a locator when the lights are off so you can find the dimmer control in the dark
• Provides protection against memory loss or damage from static discharges or surges up to IEC Level 4 standards
• Built-in radio frequency interference (RFI) filter is standard for filtering interference from radio, audio and video equipment
• Used for any environment within the temperature range of 32°F - 131°F (0°C - 55°C)
• 4 terminal screws are included for line, load, remote and ground
• 5-year limited manufacturer's warranty to be free from defects and workmanship
• ISO 9001 registered

Vizia 600W Dimmer Switch dimension drawing

Compatibility

• Vizia +™ dimmers must be used with compatible Vizia+ remotes for multi-location dimming. Standard 3-way or 4-way switches are not compatible with these dimmers
• You can mix Vizia and Vizia RF devices in multi way circuits but only RF devices will send Z-Wave commands that are radio frequency commands
• These dimmers use Decora or Decora Plus™ screwless wall plates sold separately

Notes for a Safe installation

• Always install electrical equipment following the electrical codes and regulations for your geographic area
• Use with incandescent or 120V halogen fixtures or low voltage magnetic transformers only to avoid any damage or overheating of your appliances
• Use only copper or copper clad wire when installing your Vizia dimmer
• Recommended wall box depth is 2.5" for insertion of the dimmer
• Total minimum load required must be at least 40W
• There is a maximum of 5 LED dimmers that can be installed in one circuit
• It is normal for dimmers to feel warm during operation
• Always disconnect power at the circuit breaker or fuse box before installing any electrical device including dimmers
• Further details on installation can be found in the installation manual (see below)

Maximum Load Per Dimmer For Multi Device Applications:
If you are installing in a multi device application in one junction box, the reduction of the dimmer's wattage capacity will be necessary.

• Single load maximum is 600W (Watts)
• Two device maximum is 500W
• More than 2 device maximum is 400W

These incandescent dimmers have a maximum output of no less than 95% of the line voltage

MANUALS -

• Installation Insructions
• Wiring Diagram

RELATED ARTICLES

• Spend Money to Save Money: Smart Investments That Will Help You Survive the Recession
• 5 Bright Ideas for Updating Your Home Lighting
• The History of Leviton
• Energy Saving Tips for Businesses
• Harold Leviton: Electrical Industry Innovator and Icon
• 5 Things That Home Design Shows Don't Always Tell You

VIEW OUR GLOSSARY