Perform Multiple Tests with JDSU Tri-Porter™

• Single-ended continuity test
• Complete continuity test with cable test remotes
• Cable trace and location
• Trace coax cable to device or through splitter
• Measure cable length; map cable locations
• ID unknown jacks or plugs; identify cable termination at active Ethernet ports
• Ping to verify connectivity to network devices
• Power premise telephone wiring with dial-tone simulation; provide talk battery
• Measure basic RF signal level
• Test telephone circuits for caller ID and other features
• This tool allows you to perform a battery of valuable tests for installation and maintenance of premises networks

Applications

• Voice services testing: Check and verify drops
• “PC-less” connectivity to Internet check
• Detect if there is signal from cable service provider
• Configure and test network cable for Ethernet services
• Verify that active network equipment has sufficient capabilities
• Assure wiring condition and the length of the cable
• Identify and troubleshoot cables with tone and trace functionality
• Identify cable termination location at drops and active equipment

Tests that each telephone outlet is functioning properly, and assures there are acceptable signal levels for all offered services.  Able to power-up telephone systems with the SLIC system (on-board dial tone simulator) to test connected runs.

• Telephone butt set equipped with advanced settings for extensive testing
• Call analysis and discovery for detailed reports
• Voltage and current readings allow you to gauge the cabling and system strength
• Line number discovery with captured digits for easy identification
• DTMF decode to watch dialed call numbers for accuracy
• Call waiting service testing for a thorough test
• Speakerphone for hands-free listening to dial tone and line monitoring
• DSL safe
• 20-pc remote wire-mapping set

This device is able to test newly-installed network cables even on systems without power, and checks active working networks to detect any physical layer or configuration problems.

• Multi functioning tester will configure the network, test the cables and guarantee the quality of the system
• Meets TIA568 interconnect guidelines and connected length; CAT5, 5E and 6
• Port discovery—ISDN, POTS, Token Ring, Ethernet and more
  • Negotiates at 100 Mbit with DHCP or manual addressing
• Retrieves IP address information and configuration by pinging
• Identifies equipment on the other end of the line, showing its speed and type
• Link speed displayed, 10/100Mbit
• Hub link to find connected ends in wiring closets
• Qualifies lines for VoIP service at 100Mbit speeds
• Cisco Discovery Protocol ready

In order for your HDTV, video-on-demand, cable modems, and the like, to function well, you need a high quality signal to be received. The ability to test for physical and electronic variations will guarantee that everything works as it was designed.

• Identifies any possible opens or shorts
• Identifies the length of each run
  High quality tone signal is picked up by the Tri-Porter™ as it travels through splitter
• Filters and traps to trace lines while the system is powered-up and in-use