Home > Tools & Cases > Hand Tools > Wire Installation > Lubrication Supplies & Systems > UG512ST UltraGlider 12V Kit
UG512ST UltraGlider 12V Including Slip-In Applicator UGSAK & Threaded Applicator Kit UGTAK
Safer, More Efficient, and Applies Lube More Evenly Than Can Be Done By Hand
![]()
Greenlee UG512ST UltraGlider
This requires one or more of the following: javascript enabled, Flash Video Player, and Quicktime or Windows Media Player Bucket of Lubricant NOT included |
What's special about this UltraGlider?
|
The Greenlee UG5 Ultra GLIDER™ is the “new way” to effectively apply cable lube during cable installation. The Ultra GLIDER™ has several advantages over the manual method used by most contractors today. The UG5 saves labor time - in many cases one person can be eliminated during the job because the same person who controls the feeding of the cable can also control the cable lube application. Cable pulling force is reduced by up to 50% because the lube is applied consistently. It also saves lube cost because it applies lube consistently in a controlled manner.
| Pump Unit | 39" H x 18" W x 17" D [1 m x 0.45 m x 0.43 m] |
|---|---|
| Wheel Diameter | 8" [20cm] |
| Hose Length | 10' [3m] |
| Battery (12V Unit only) - Type | Sealed lead acid rechargeable batter, DC output 12-Volt |
| Battery Life | Three to four 5-gallon buckets per charge |
| Warranty | One year |
| PART # | DESCRIPTION | WEIGHT | PRICE |
| GL-UG512ST | UltraGlider 12V Including Slip-In Applicator Kit & Threaded Applicator Kit | 100.5 lbs |
Instruction Manuals
How to Set up the Pump | |
| Step: 1 Place a 5 gallon bucket of lubricant into the dolly and remove the lid from the bucket. |
Step: 2 Place the Follower Plate inside the bucket, setting it on top of the lubricant with the hub facing up, and press down to remove any air pockets. |
Step 3: |
Step 4:
|
Step 5: |
Step 6: |
RELATED ARTICLES -







