UG512S UltraGlider 12V Including Slip-In Applicator Kit UGSAK
The Greenlee UG5 Ultra GLIDER™ is the “new way” to effectively apply cable lube during cable installation. The Ultra GLIDER™ has several advantages over the manual method used by most contractors today. The UG5 saves labor time - in many cases one person can be eliminated during the job because the same person who controls the feeding of the cable can also control the cable lube application. Cable pulling force is reduced by up to 50% because the lube is applied consistently. It also saves lube cost because it applies lube consistently in a controlled manner.
|Pump Unit||39" H x 18" W x 17" D
[1 m x 0.45 m x 0.43 m]
|Wheel Diameter||8" [20cm]|
|Hose Length||10' [3m]|
|Battery (12V Unit only) - Type||Sealed lead acid rechargeable batter, DC output 12-Volt|
|Battery Life||Three to four 5-gallon buckets per charge|
|Warranty||One year manufacturer|
|GL-UG512S||UltraGlider 12V with Slip-In Applicator Kit (UGSAK)||85.5 lbs||DISCONTINUED|
MANUALS & USER GUIDES -
- User Manual (PDF)
How to Set up the Pump
Place a 5 gallon bucket of lubricant into the dolly and remove the lid from the bucket.
Place the Follower Plate inside the bucket, setting it on top of the lubricant with the hub facing up, and press down to remove any air pockets.
RELATED ARTICLES -
- Key Elements for Cable Installation Success
- The Facts on Polypropylene
- How to Start an Arc Flash Prevention Program
- Which Firestop Product Should I Use for My Application?
- What is the Difference Between Cable Shielding and Insulation?