The Triplett SatAlign is a quick and economical way for the do-it-yourselfer to install or realign a DBS satellite dish. No need to pay for expensive service calls! Just connect the SatAlign between the LNB and any DBS Satellite Receiver and you can precisely align your dish in seconds. The SatAlign, with its built-in signal strength meter, is extremely sensitive with a quick response time making satellite alignment a breeze. The SatAlign works with all brands of dish antennas and satellite receivers. It will save you hours of installation time and guarantees exact alignment for the best picture quality and maximum rain fade reserve.
- Built in integrator for broad band frequency scanning
- LED indicator for left hand (18V) or right hand (13V) polarization
- Powered by the satellite receiver or external power source
- 1-year limited manufacturer warranty
|Frequency Range||950MHz to 2050MHz|
|Input Impedance||75 ohm|
|Max. Input Level||-10 dBm|
|Detection Range||-40 to -10 dBm|
|Insertion Loss||4 dB approx.|
|Indication: Main||Analog Panel Meter|
|Connector||“F” Female type|
|Dimensions||95(W) x 55(D) x 30(H) mm|
|Power Source||Powered by the Satellite Receiver. There is also a power jack located under the "RX" terminal which can be used to power the SatAlign with an external source. The center pin on the jack is "+". The level of external power should match the required power for the LNB to be used. If the power level is less than 15V ± 0.5V, the 13V LED will light. If the power level is more than 15V ± 0.5V, the 18V LED will light.|
|TR-3275||SatAlign Digital Satellite Strength Meter||Black|
What can make this page better?
We do everything we can think of to provide you with the product specs, images and ordering info you need, but if we’re missing something or still have room to improve, please let us know. Your comments, suggestions and questions are the best tools we have for serving you better!