Enhanced Server Enclosures Technical Specifications and Features

  Frame

• Rugged reinforced base w/14 gauge post for increased weight capacity
• Same top & door options as the Enhanced Series Enclosures
• 1800 lbs. weight capacity on casters
• Convenient 3/4" anchoring holes allow easy access for bolting enclosure to floor
• Front and rear doors and top panel have mesh panel inserts for ventilation
• Networkable (side by side ganging)
• Split side panels, lighter for easier handling
• Increased strength with center side posts between side panels

 Cable Access

• Generous cable access
• Corner posts have three 2.5" x 6" knockouts, allowing cable between enclosures
• Top back has two 2.5" x 6" knockouts
• Cables can enter the enclosure through 3 locations:
• Opening in the bottom rear - 24"W x 3.75"D for 29"W enclosure and 19"W x 3.75D for 24:W enclosure
• Opening in front of the rear opening - 13.5"W x 4"D for 29"W enclosure and 8.5"W x 4"D for 24"W enclosure
• The center opening 11.75"W x 14.75"D for 29"W enclosure and 6.75"W x 14.75"D for 24"W enclosure

 Rails

• Maximum rail spacing, front to rear, is 36"
• The Universal rails (M6 - 12 gauge) are infinitely adjustable
• These rails can accept multi-vendor "server specific" side mounting adapters
• Reversible rails are marked with RMU count
• Cinch strap/wire tie locations on side of rails both horizontal and vertical

 Anti-tip Legs

• AT1 - Retractable anti-tip legs mount to the outside bottom of the frame and can be used when the cabinet is on glides or casters
• Retractability allows you to safely clear the aisle

 Cable Management

• Front & rear vertical cable management run in each rear corner post (optional QGL-CME-42ES)
• Horizontal cable management left to right in the top front/rear with “waterfall” edges to protect cables. (optional QGL-HCM-W29ES)
• Horizontal cable management front to rear (optional QGL-HCM-D42ES)
• Cable loop lance located at the bottom rear opening allow you to secure your incoming cable

  Cable Management when Networked

• No tools required for Networking - Kit QGL-G101
• Numerous cable access knockouts in frame sides and top allows cable to pass from enclosure to enclosure without exiting frames. (with side panels installed)
• Saves cables from exposure and on cable length
• Exclusive design allows internal cabling to pass through multiple enclosures. (i.e. an internal mini ladder rack system included!)