Arlington Industries Reversible Entrance Plates

• Optimal method for passing cabling through walls
• This product is non-rusting and paintable so you know it will last and match all your décor
• Available in black or white
• Includes matching screws
• Made of:
  • Plastic
  • Non rusting
  • Non-metallic
  • Paintable

This product has starred in our Product Showcase Blog! Click here to check it out.

PRODUCT SPEC SHEETS

• CED1 (PDF)
• CE1 (PDF)
• CE2 (PDF)
• CER1 (PDF)
• CER2 (PDF)
• CEH1 (PDF)

This product has starred in our Product Showcase Blog! Click here to check it out.

The SCOOP™ Series Entrance Plates & Hoods CE1 and CE2 Series

This consists of the plate and the scoop and is reversible. Install one of Arlington's low voltage mounting brackets (not supplied) at entry and/or exit locations. Use LV1 for the single-gang CE1, and LV2 for the two-gang CE2.

    Installation Instructions:

1. At point of entry: Use the mounting bracket as a template, and cut hole for entry location. Feed wires into the cable entrance plate. Make sure that the hood is in the desired orientation; facing in or out.
2. At point of wire exit: Install low voltage mounting bracket (repeat above instructions). Fish wires from behind the wall surface and pull through the bracket. Feed wires into CE1 or CE2 with the hood in the correct orientation (in or out).
3. Attach both (entry and/or exit) cable entrance plates to the LV1 or LV2 mounting brackets.
4. Connect wires to electronic equipment.

The SCOOP™ Series Entrance Plates & Hoods CED1 Reversible Cable Entrance Hood for Decorator Plates

• Quickly and easily install facing in or out
• For use with decorator style wall plates
• Single gang size Installation Instructions

Use one or more of Arlington's low voltage mounting brackets (not supplied) to install The SCOOP™ - the single-gang LV1, two-gang LV2, three-gang LV3 or four-gang LV4.

    Installation Instructions:

1. Use the mounting bracket as a template, then cut hole for entry location. Attach the mounting bracket to the wall.
2. Feed wires through The SCOOP™ (CED1), with it facing in or out, as desired. Attach to the mounting bracket with the supplied screws. Repeat as many times as necessary.
3. Connect wires to electronic equipment.

The SCOOP™ Series Entrance Plates & Hoods CER1 and CER2 Series
This plate is an innovative creation which came from necessity. How many times have you installed cabling only to find you missed a cable and now you must redo the entire job? With the CER1 and CER2 simply remove the bottom piece and include your runaway cable.

MANUALS -

• CE1, CE2 Brochure (PDF)

RELATED ARTICLES

• What Is Plenum Cable, and When Should I Use It?
• The 10 Commandments of Cable Management
• What Is The Difference Between Cat 5, Cat 5e, and Cat 6 Cable?

VIEW OUR GLOSSARY